Three variables should be set on order to make bash
understand the
8-bit characters. The best place is ~/.inputrc
file. The following should be set:
set meta-flag on set convert-meta off set output-meta on
The following should be set in .cshrc
:
setenv LC_CTYPE ISO-8859-5 stty pass8
Use 'rlogin -8
'
The minimal cyrillic support in emacs
is done by adding the following
calls to one's .emacs
(provided that the Cyrillic character set
support is installed for console or X respectively):
(standard-display-european t) (set-input-mode (car (current-input-mode)) (nth 1 (current-input-mode)) 0)
This allows the user to view and input documents in Russian.
However, such mode is not of a big convenience because emacs
doesn't
recognize the usual keyboard commands while set in Cyrillic input
mode. There is a number of packages which use the different
approach. They don't rely on the input mode stuff established by the
environment (either X or console. Instead, they allow the user to
switch the input mode by the special emacs
command and emacs
itself is responsible for re-mapping the character set. There are, at
least, two packages of that type. One is cyr.el
. It can be found
in most Emacs-Lisp archives. The other one is the package remap
which tries to
make such support more generic. This package is written by Per
Abrahamsen (abraham@iesd.auc.dk
) and is accessible at
ftp.iesd.auc.dk
.
So far, less
doesn't support the KOI-8 character set, but the
following environment variable will do the job:
LESSCHARSET=latin1
Check the
sunsite.unc.edu:/pub/academic/russian-studies/Software
for
the russian dictionary created by Neal Dalton (nrd@cray.com
) for
the ispell
package.
Set the following resource:
*documentFonts*registry: koi8
Next Chapter, Previous Chapter
Table of contents of this chapter, General table of contents
Top of the document, Beginning of this Chapter